1. Be sure to wear the proper safety gear while chainsawing, including a hardhat with face shield and hearing protection, thick work gloves, ballistic-nylon chaps, and non-slip work boots.
2. Fill the chainsaw with gas/oil mixture; refer to the owner's manual for the correct proportion of gas to oil.
3. Add bar-and-chain lubricant to the saw's reservoir.
4. Check the tension of the saw chain. While wearing gloves, pull the chain away from the bar and release it. It should snap back, but still move freely around the bar. Tighten or loosen the adjustment screw, as necessary, to properly tension the chain.
5. Be sure the chainsaw's safety features are operating properly, including the throttle interlock, chain brake, and chain catch.
6. Use a chainsaw file with guide to sharpen the cutting teeth on the saw chain.
7. An option to filing is to sharpen the chain using a grinding-stone attachment.
8. Fasten the grinding-stone attachment to the tip of the bar. Start the saw on the ground, then push the point of the sharpener against a log. Hold it there for three to five seconds while running the saw to sharpen the chain.
9. When cutting a long log, use the saw's bar to measure and mark the log into 16-inch-long sections.
10. Saw three-quarters of the way into the log, then rotate log and complete the cut. Be careful not to cut into the ground or have the tip come in contact with a nearby log.
